introduction of Roots Blower

The safe operation and service life of roots blower depend on whether they are regularly maintained and maintained properly. Attention should be paid to any accidents. If three-lobed roots blowers are not in service, all power of the equipment should be cut off. It is suggested installed in a ventilated and dry place, which can effectively prevent the body from rusting and other phenomena during long-term non-use. In addition, during the use of Roots blowers, they must be lubricated regularly. Only in this way the flexibility of blower be guaranteed.

In addition that, you should also pay attention to the following points:

1. Check the tightening of various parts of the Roots blower and whether the positioning pins are loose.

2. There must be no scale, rust and peeling inside the blower body. Prevent oil leakage inside the body.

3. When disassembling the machine, measure the dimensions of each fit of the machine, make a record, and make marks and directions on the parts to ensure assembly and maintain the original fit requirements.

4. The overload of the roots blower is sometimes not displayed immediately, so pay attention to the changes in the intake and exhaust pressure, bearing temperature and motor current to determine whether the machine is operating normally.

5. Under normal conditions, the lubrication must be replaced for 1000 hours of operation. Pay attention to whether the cooling condition of the lubricating oil is normal, and the quality of the lubricating oil, whether the abnormal  noise of the Roots blower exist, and pay attention to whether the unit works under the specified operating conditions.

6. The new machine or Roots blower after overhaul is put into operation according to the use procedure. It is recommended to replace all the lubricating oil after 100 hours of operation. Routine maintenance is very important, minor faults must be repaired before being put into use.